Replace the suction nozzle and pickup plate and alter the settings.
䐟
Turn the rotating shaft of the rivet rotary unit to a position where the suction
nozzle can be pulled.
䠍
ᾁ
Replace the suction nozzle and re-assemble in reverse order from above.
䠍
ᾂ
Adjust the angle adjuster plate to 30° or 60°. (Refer to page 9)
䠍
ᾀ
䕻
Suction nozzle replacement
Suction nozzle
㻖㻌
Gently turn the rotating shaft with your hand and
ensure that there is suffi
cient clearance between
the rotating shaft and the block, so that there is
no obstruction in operation.
㻖㻌
If it is diffi
cult to pull out, use a machine such as a
fl athead screwdriver.
䐠
Pull the collar of the suction nozzle to remove.
䕻
Optional parts
䠍䠐
ᒍᛖᾔ
ᾝ
ᾖ
ᾛᾘ
ᾢ
ᾗ
Suction nozzle
䠄
Type3
䠅䚷䚷
Code No.
䠖
65287
Suction nozzle
䠄
Type4
䠅䚷䚷
Code No.
䠖
65288
Suction nozzle
䠄
Type5
䠅䚷䚷
Code No.
䠖
65289
⅐ ⁂⁕⁗⁖⁗‒⁘‒⁕⁚⁓⁙⁛⁙‒⁛⁗‒⁓⁖‒⁛⁗⁗
ᾀ
Change in diameter of rivet
㻖
If the rivets are remaining inside, take off brush cylinder unit and remove the rivets.
Push in by hand.
Suction nozzle
Clearance block
When changing rivet diameter or riveter frame head diameter, follow the procedures
shown below. When changing rivet diameter or frame head diameter, replace with optional
parts. Prior to changing and replacement of any parts or components, always disconnect the
air hose and power cable.
㻖㻌
Make sure which spare parts are currently used referring to page 26, and change to required
optional parts, referring to pages 27 and 28.
㻖㻌
Optional parts are sold separately. Contact the supplier you purchased the product from, or
contact Lobtex. (Refer to pages 14 and 16)
⚠
ᵡᵟᵳᵲᵧᵭᵬᴾᵏᵆᵮᵌᵑᵇ
