Author: JJ Contributors: Date: 3/18/2022 Revised:
TS- My Machine Won’t Hold a Charge (Grand Machines)
Troubleshooting Instructions
Step 3- Checking the Charger
1.
Check the charger by plugging it into the
wall outlet (the LED on the charger itself
will light up green), and then connect it to
the XLR charging port on the machine.
If
the LED on the charger does not light
up, or is flashing either Red or Green,
then the charger is faulty, and needs
to be replaced.
The LED on the charger
should turn Red showing the battery is
charging. If the charger LED is still Green,
it could mean a disconnected XLR
charging wire.
please move onto step 4 to check the Power wires,
and XLR charging wires.
LED on charger Green light.
LED on charger Red.
Step 4 – Check Main Battery Wires
1.
There are 2 Red wires connected to the positive
section of the battery. 1 of these red wires should go
to the Reset Switch (The reset switch is located
underneath the back of the machine on the right
hand side.). The other red wire from the positive
section of the battery should go to the XLR charging
port (this is the 3 pronged charging port you connect
your charger to).
Battery Terminals (grand series).
Red XLR wire, and Red reset
switch wire to battery.
