Elite Model, 1, 2, 3, Pickle 2
TS
–
My Elevation Is Not Working
Author: CT
Contributors: JR,RR, JJ
Orig. date: 9/20/10
Revised:12/15/2021
2.
For the elite 1 and Pickle 2 machines, check to make sure the
Should Bolt attaching link arm 1 and link arm 2 is present. If
both arms are away from each other, you will need to re-
attach them with a shoulder bolt. (
if your shoulder bolt is
missing you will need a new one, item E363
).
If the Elevation link is firmly attached to the elevation motor
shaft, and the link is not missing the should bolt (for elite 1
and Pickle 2 machines) then continue on to the next section.
8
Putting the Yoke Back On to The Davit.
1. Lift up the Yoke Assembly and slide onto the Davit Assembly so
that the Yoke Wheel portion of the yoke is on the right of the Davit
Center, and the Motor Support Bracket is in-between the Davit Right
and the Davit Center.
2. Slide the long bolt threw the hole in the yoke, which passes from
the right of the yoke, all the way to the left. (Please follow the
diagram below which shows where the yoke spacer long, and short,
and washers belong.)
Using a Washer and the yoke bolt nut, tighten until the yoke is
secure. (*
Do NOT over tighten the yoke or your elevation will not
move.)
The Server wheels.
The Yoke Bolt being installed.
