Elite Model, 1, 2, 3, Pickle 2
TS
–
My Elevation Is Not Working
Author: CT
Contributors: JR,RR, JJ
Orig. date: 9/20/10
Revised:12/15/2021
2. There are 2 large screws in the front bottom section
of the Red Case, and 2 large screws on the case
side. There are 2 smaller screws located
underneath the control panel that secure the red
case back.
Case Screws (Side)
6
Removing The Yoke Assembly
1.
Take off your server wheels by unscrewing the set screw,
and sliding the wheels off of the server motor shafts.
2.
With the front end of the machine facing you (the pointer
closest to you, and the handle furthest from you), remove
both of the server wheels.
3.
Passing through the center of the Yoke and the davit
assembly is the Yoke Bolt. (This bolt has a nut holding it on
the end of the Davit Right). Using a Crescent Wrench and a
9/16” Wrench, unscrew and remove the Yoke Bolt
(Hold onto
the Bolt side between the Server Wheels with the Crescent
Wrench, and use the 9/16´´ Wrench to hold onto the nut on
the opposite end of the bolt), and remove the Small and
Larger Spacer, and the 3 to 5 washers. *(
Carefully set these
in separate safe location for later use.
)*
(Elite model 1 link, shoulder bolt, location)
The Server wheels.
The Yoke Bolt being removed.
Elite 1 link and shoulder bolt
Elite 2&3 and Pickle 2 link and
shoulder bolt.
