4
START UP MANUAL
QUICK LOAD SERVO S2
3.
Press the numeric key
[3]
(Position/Torque).
The display reads :
END OF BAR POSITION
****MM
4.
Press the key attributed to the icon
[SET]
.
Depending on which sequence the bar feed is in when the parameter is selected, the
available functions and icons can change :
Functions
Conditions
By offset correction
By teaching
- Loading channel down
- No bar stock in the loading channel
Icon
: [+/-]
Icon :
[TEACH IN]
[+/-]
By offset correction
C
Press the key attributed to the icon
[+/-]
.
The display reads the current end of bar position.
C
Enter the correction value with the numerical keys. Then, press the key
attributed to the icon
[+]
to add the value, or the key
[-]
to substract it. The
display reads the new end of bar position.
C
To exit the end of bar set mode, press the key attributed to the icon
[ESC].
[TEACH IN]
By teaching
C
Press the key attributed to the icon
[TEACH IN]
.
The display reads the current end of bar position
C
Press the key
[FWD]
and advance the pusher to the desired position (see
previous page).
C
To validate the new end of bar position, keep
[ENTER]
pressed until the icon
disappears
.
5.
To exit the set mode, press the keys
[MENU]
or
[STOP]
.
Note:
If only the OFFSET function is needed, this can be accomplished by pressing [1] in
sequence 3 above, then pressing the key attributed to the icon [PAGE DOWN] until the
parameter is displayed. The "Teach In" function is not available in this menu.
Summary of Contents for QUICK LOAD SERVO S2
Page 1: ...ENG MADE IN USA ...
