18
START UP MANUAL
QUICK LOAD SERVO S2
Note :
The shorter
the shaped
bar, the more
difficult it will
be to position
it.
5.2
Shaped bars (hex and square)
a)
Lathes without spindle orientation
For all lathes without spindle orientation, it is possible to install a bushing, inside the
clamping device, with the same inside profile (+0.2 mm) as the bar.
The rear of this collet and the front of the bars should be flat.
During the loading cycle, a slight rotation of the spindle (about 30 RPM) is desirable).
b)
Lathes with spindle orientation
When the material is located in the loading channel, it is "oriented", so to speak, in
position. The profile of the clamping device should be positioned with regard to the
profile of the bar.
If the bar is of the same length as the spindle, at the time it leaves the loading channel it
should already be inserted into the clamping device.
If the distance between the front of the bar feed system and the rear of the spindle is
significant, and the bar has already left the loading channel, but is not yet inside the
clamping device. It is advisable to install in back of the spindle a "Profiled" shaped
support to "keep" the bar oriented while it is being inserted by the loading flag into the
clamping device.
Summary of Contents for QUICK LOAD SERVO S2
Page 1: ...ENG MADE IN USA ...
