LNS Eco Load S2, Instruction Manual

Page: 107 / 112

CHAPTER 8: TROUBLESHOOTING GUIDE 8-9
ECOLOAD S2
e21 Pusher moving distance is too long when chuck is closed
Description
The pusher moving distance is larger than <Too long dist>
setup in P01 when the lathe chuck is closed.
Troubleshooting
1. Check if the chuck signal received but the lathe chuck is
still closed.
e22 Check bar ejection setup
Description
Ejection position was exceeded prior to BAR END position.
Troubleshooting
1. Check if BAR END setup is too big and adjust it.
2. Check if ejection position is too small and adjust it.
e23 Remnant ejection is failed
Description
The pusher fails to exceed remnant ejection position within 10
seconds after chuck open.
Troubleshooting
1. Check if the remnant blocked inside the spindle.
2. Check if ejection position setup is too large.
e24
This message intentionally left blank.
e25 TOP CUT setup is smaller than bar stock length
Description
TOP CUT setup was detected to be smaller than the measured
bar stock length during FIRST FEED.
Troubleshooting
1. Check if the TOP CUT setup value is too small.
2. Check if the TOP CUT device was activated earlier.