Instruction manual
10
connection for leakage using soapy water. Any leakage will show as bubbles in the area of the leak. If
leak is found, do not use the barbecue and turn off the gas supply. Consult your gas or barbecue
supplier for advice.
4.
Push down and turn on the burner, at the same time, press on the red button of ignition, an audible
click will be heard and then the burners will be light.
5.
If the burner has not lit after two attempts, turn ‘OFF’ the gas tap and wait 5 minutes before retrying
the ignition sequence.
6.
When the burner has lit, the burner rate can be adjusted by turning the knob anticlockwise to any
position between the full and low rate positions.
7.
Light the remaining burners from left to right in sequence.
8.
To switch off the plancha, cut the gas inlet by turning the button of the valve or the regulator in position
"Stop", by following the instructions supplied with the regulator. Turn the buttons of all the burners in
the directions of watch hands, in position "Stop" switched off,(faded), when flames are switched off.
Warning:
If any burner fails to ignite, turn the control knob off (clockwise) and also turn the cylinder valve
off. Wait five minutes before attempting to relight with ignition sequence.
After use, close the gas supply by either turning ‘OFF’ the switch on the regulator or turning ‘OFF’ the
cylinder valve.
In the event of light back whilst the appliance is in use. Turn all the controls, cylinder valve and regulator
switch to the ‘OFF’ position. Wait 5 minutes before attempting to relight the appliance. If the problem
persists after relighting, consult your gas dealer, or the store where you purchased the barbecue, or a
qualified gas engineer for assistance or repair. Never try to rectify the problem yourself as this could result
in serious injury and/or property damage.
Clean the appliance of excess fat, before storage, with a damp cloth using a mild detergent solution as the
cleaning agent.
Store the appliance in a clean dry environment.
Do not store your gas cylinder indoors. Store in a well ventilated area away from direct sunlight.
CONNECTING THE GAS CYLINDER TO THE APPLIANCE
This appliance is only suitable for use with low-pressure butane, propane or their mixture gas and used with the
appropriate low-pressure regulator via a flexible hose. The hose should be secured to the regulator and the
appliance with hose clips.
- Using 28mbar regulator with category I3+ for butane gas and a 37mbar regulator with category I3+ for
propane gas;
- Using a 30mbar regulator with category I3B/P (30);
- Using a 37mbar regulator with category I3B/P (37);
- Using a 50mbar regulator with category I3B/P (50);
Use a suitable regulator certified to BSEN 12864:2001.
Please consult your LPG dealer for information regarding a suitable regulator for the gas cylinder.
BEFORE USE PLEASE CHECK FOR LEAKS
Never check for leaks with a naked flame, always use a soapy water solution
