9
US-EN
with plenty of clean water and immediately
seek medical advice!
WEAR PROTECTIVE GLOVES!
Leaking or damaged batteries/
rechargeable batteries can cause
burns if they come into contact with the
skin. Therefore wear suitable protective
gloves in such cases.
In the event of leaking batteries, remove
them immediately from the product in order
to prevent damage.
z
Assembly and installation
Note:
remove all packing materials from the
product. Decide prior to mounting where the
product is to be mounted. Before drilling the
fixing holes, make sure that there are no gas
or water pipes or power cables that could
be drilled into or damaged in the area
where you are drilling. Use a drill to drill
holes in the wall. Please note the safety
instructions in the instruction manual of your
drill. Otherwise there is a risk of serious or
fatal injury from electric shock.
Note:
the fixings included are intended for
standard solid masonry walls. You should
check independently what type of fixings are
most suitable for the surface on which you
intend to mount the product. If necessary,
you should seek the advice of an expert.
When deciding where to mount the
light, pay attention to the following
Make sure the product illuminates the
selected area properly. Make sure that the
motion sensor
4
is facing the desired
detection area.
The motion sensor has a maximum
detection range of 10m with a field of view
of approx. 120°.
Make sure the motion sensor
4
is not in a
position where street lights will shine on it
at night. This may result in diminished
functionality.
The recommended installation height is 2 to
4m. If possible, mount the Spotlight in a
position not exposed to dust and dirt where
it is protected from rain (e.g. under a roof
projection) and other weathering effects.
Note:
the solar panel
2
requires as much
direct sunlight as possible. Even if the solar
panel is only partially in the shade during
the day, it can significantly impair the
charging process.
Orientation:
The optimum alignment is facing south.
Choose an orientation facing slightly to the
west rather than slightly to the east.
z
Mounting the Spotlight
Transfer the positions of the guide holes
3
/
13
to the mounting point on the wall.
Drill two holes (dia. 6mm) and insert the
matching wall plugs
8
(see Figs. C and
G).
Mounting model 1020-B
Screw the screws
7
into the wall plugs
8
,
leaving a gap of approx. 3mm between the
screw head and the wall (see Fig. C).
Slot the guide holes
3
over the screws and
then slide the Spotlight along the guides to
fix it in place (see Fig. C).
If necessary, adjust the gap between the
screw heads and the mounting surface to
provide a firm seating for the Spotlight.
Mounting model 1020-S
Screw the wall bracket
11
firmly in place
by inserting the screws
8
through the
guide holes
13
into the wall plugs
8
and
firmly tightening them (see Fig. G).
Fix the Spotlight to the wall bracket
11
by
loosening the Spotlight star knob
9
and
removing the screw
12
�
Align the holes in the Spotlight with the
holes in the wall bracket and slot the screw
12
through the holes (see Fig. F).