9
GB/IE/NI
immediately with plenty of clean water and
seek medical advice immediately!
WEAR PROTECTIVE GLOVES!
Leaking or damaged rechargeable
batteries can cause chemical burns
if they come into contact with skin�
Therefore, wear suitable protective gloves in
such cases�
In the event that of battery leaks, remove
battery from the product immediately to
avoid damage�
z
Assembly and installation
Please note:
Take the product out of its
packaging and remove all packing material�
Check that all package contents are
present�
Check if the product or individual parts are
damaged� Should you detect damage, do
not use the product� Please contact the
retailer via the service address indicated�
Decide prior to mounting where the product
is to be mounted. Before drilling the fixing
holes, satisfy yourself that there is no danger
of drilling into or damaging gas or water
pipes or electricity cables in the position
where you are about to drill the holes� Use a
drill to drill the holes into the masonry�
Observe all safety instructions provided in
the operation and safety manual for your
drill� Otherwise there is a risk of serious or
fatal injury from electric shock�
Please note:
The fixings included are
suitable for conventional solid masonry�
Please check independently what kind of
fixings are best suited for the surface on
which you intend to mount the light� If
necessary, you should seek the advice of an
expert�
What to consider when deciding on
where to mount the product:
Ensure the product illuminates the desired
area�
The motion sensor has a detection range
(field of view) of 1-10 m. Make sure that
the motion sensor covers the desired area�
The recommended installation height is 2 to
4 m�
If possible, mount the spotlight in a position
where it will not be exposed to dirt or dust
and is protected from rain and other
weathering effects�
Please note:
The solar panel
1
should be
positioned where it will be exposed to as
much direct sunlight as possible� Even partial
shade during the day can significantly
impair the charging process�
Orientation:
The optimum alignment is facing south�
Choose an orientation facing slightly to the
west rather than slightly to the east�
z
Mounting the spotlight
The spotlight can be mounted either on a
straight wall or on a corner using the wall
bracket (see Fig� C)�
Please note:
Make sure that you mount the
wall bracket the correct way round� Refer to
the arrows shown in Figure C for guidance�
With the wall bracket
4
in its intended
mounting position, mark the positions for
the fixing holes on the wall using either the
guide holes
5
(for mounting on a building
corner) or guide holes
6
(for mounting on
straight wall) (see Figs� B and C)�
Drill two holes (dia� 6mm) and insert the
matching wall plugs
7
(see Fig� C)�
Screw the wall bracket
4
(for straight-wall
or corner mounting) in place by inserting
the screws
8
through the guide holes
5
/
6
and firmly tightening them. Check that
the wall bracket is fixed firmly in place.
Slot the spotlight onto the wall bracket
4
