10
LITTLE
WONDER
PROVAC SI
SET-UP INSTRUCTIONS
5. Using the upper handle tilt the unit back and rest the
Intake Nozzle on a block 2-3 inches off the ground.
Using the adjustable 9/16” wrench, remove the
hardware that is already fastened to the short free
end of the Bell Crank. With the plastic washer in
the middle, fasten the long connector bracket to the
bell crank as shown in
Figure 3
. Tilt the unit back,
remove the block and return the unit to the upright
position on the ground.
Ensure the connection is
free enough to rotate. Do NOT overtighten.
6. The throttle cable comes pre-assembled to the
engine. Free the control end of the throttle and route
it underneath the lower handle and to the inside
of the height adjust linkage. Insert the 1/4-20 bolt
first through the handle, then the center hole of the
throttle as shown in
Figure 4
. Using the adjustable
wrench and the 3/8” wrench, loosely fasten with the
1/4-20 nut.
7. With the 5/16 nut driver, fasten the throttle to the
upper handle using the 10-32 thread forming screw
as shown in
Figure 4
. Now, fully tighten the 1/4-20
nut securely but not so much as to crush the tube.
Secure the throttle cable to the upper handle with a
cable tie as shown in
Figure 5
. Trim off the excess
cable with side cutting pliers.
