![background image](http://html1.mh-extra.com/html/little-wonder/9270-12-01-gx270-honda-sp/9270-12-01-gx270-honda-sp_operators-and-parts-manual_1929664010.webp)
10
LITTLE
WONDER
BLOWER
FIGURE 5
FIGURE 6
FIGURE 7
FIGURE 8
8. Move the deflector control lever to the front of the
slot. Adjust the jam nuts on the cable fitting so
the deflector is completely closed. Lock the nuts
against the bracket when the adjustment is correct.
9. Secure the throttle and deflector cables to the
handle tubes with cable ties from the hardware
package. Trim off excess. (Figure 5)
10. Move the speed control lever
A
all the way
forward. Turn the vertical rod
B
into the swivel
C
on
the speed control. Pull up on the rod
B
to move the
speed control to its forward stop. Turn the rod in or
out of the swivel unit it just goes into the pivot plate
E
. (Use the lower pivot plate hole for the upper
handle position.) Secure the rod
B
to the pivot
plate
E
with two hairpin cotters. (Figure 6 & 7)
11. Route the clutch cable up the front of the right
handle tube and around the outside of the handle.
Route as shown in Figure 6 and install the snap
retainer
D
in the hole in the speed control bracket.
(Figure 6) Lift the clutch bail to get sufficient slack
to connect the Z-bend on the end of the clutch to
the clutch bail. (If sufficient slack is not available,
the bail may be squeezed together and removed
from the handle to connect the Z-bend then
reinstall. (Figure 8)
12. Secure the clutch cable to the speed control
bracket and handle tube with cable ties as shown
(Figure 6)
10. Fill the engine with oil to the level indicated on the
dipstick. Fill the fuel tank with clean, fresh regular
grade unleaded gasoline.
SET-UP INSTRUCTIONS