13
ENG
In
fl
ation is stopped
and resumed.
Automatic re-in
fl
ation
to obtain correct
measurements.
Perhaps you talk or move
your arm during the
measurement?
See MEASUREMENT
PROCEDURE
Calm down and repeat the
measurement
Every time the
blood pressure is
different.
Measurements are
too low/high.
Check that the arm cuff is
level with your heart?
Check that the arm cuff is
applied correctly?
Perhaps your arm
muscles are tough?
Perhaps you talk or move
your arm during the
measurement?
Take the correct position for
measurement.
Take the correct position for
measurement.
Apply the arm cuff correctly.
Keep silence and quiet during
measurement.
Measurements of
the pulse rate are
too high/low.
Perhaps you talk or move
your arm during the
measurement?
Perhaps you make
measurement directly
after physical load?
Keep silence and quiet during
measurement.
Repeat the measurement at
least in 5 min.
Impossibility to
make a large
of number of
measurements.
Application of poor
batteries.
Use only alkali batteries of
well-known manufacturers.
Spontaneous
failure of power
supply.
Actuation of automatic
de-energizing system
This is not a defect. The
Device is disconnected
automatically in 3 minutes
after the last operation of the
Device.
If regardless of the above recommendation you are unable to get correct
measurement results, stop the use of this Device and apply to a maintenance
organization (addresses and telephones of authorized organizations may be found
in the warranty card). Do not try to adjust the internal mechanism by yourself.
