8
iFerm Nano Terminal
Product overview
8
3.1.1
Opening iFerm Nano Terminal
You must open the
iFerm Nano Terminal
in order to check that the scope of delivery is complete. To
do this, use a medium-sized slotted screwdriver (not supplied):
¨
Open the quick-release fasteners in the housing
cover with a quarter turn to the left.
¨
Lift off the housing cover and carefully place it
down behind the housing:
–
Use a soft underlay to protect the display when
you place it down.
–
When lifting it off, make sure that you do not
damage the cable connections of the display.
¨
Place all components on a clear and flat surface.
¨
For further assembly, it can be helpful to completely separate the housing cover from the hous
-
ing. To do this you can unfasten the plug connections on the inside of the display:
–
Undo the plug lock with a slotted screwdriver.
–
Pull both plugs off the power connection and off the COM2 port of the display.
–
If necessary, disconnect the Ethernet cable from the LAN port of the display. When unfas
-
tening the plugs, make sure that you do not break off the latching tabs (press down the
latching tab).
3.1.2
Standard components
The following components are included as standard in the
iFerm Nano Terminal
scope of delivery:
Item
Brief description
2 x
2 brackets with holes for wall mounting; can be plugged onto the rear of the
housing
120 Ω
1 x
120 Ω bus terminating resistor; terminates the free cable end of the data
bus network
1 x
Rubber seal; must be used with a thin network cable
