Rev: 05.19.2022
Page 2
CCD-0002102
As a supplier of components to the RV industry, safety, education and customer satisfaction are our primary concerns. Should you have
any questions, please do not hesitate to contact us at 432-LIPPERT (432-547-7378) or by email at
. Self-help tips,
technical documents, product videos and a training class schedule are available at
or by downloading the LippertNOW app.
TI-183
POWER AND MOTION
TI - 183 SCHWINTEK TV LIFT
PROGRAMMING AND OPERATION
4.
Set the retract limit by holding the DOWN button (Fig. 1C) on the remote (or RETRACT on the wall
switch) and stopping when the TV is fully lowered into the cabinet.
5.
Press the Configuration button (Fig. 1A) to set the retract limit.
NOTE:
Both LEDs will blink for 3 seconds and then the receiver will exit programming mode. The stops are now set.
NOTE:
If the LEDs continue to flash, reprogram the stops by going through steps 2-5.
Syncing the Remote to Receiver
1.
Push the Configuration button (Fig. 1A) on the receiver three times and hold on the third.
2.
Green and red LEDs will flash back and forth (Fig. 1).
3.
Push any button on remote (Fig. 1).
4.
When the remote is synced, green and red LEDs will flash back and forth again and then shut off.
Operation
1.
To raise the TV, press and hold the Up button (Fig. 1B) until the TV lift is fully raised into position.
2.
Press the Down button (Fig. 1C) once and release to lower the TV. The TV lift will lower the TV into the
cabinet with “One Touch” operation of the remote.
NOTE:
When replacing a remote, the TV Lift kit (
- Fig. 1) must be purchased as the remote is not
sold separately.
NOTE:
The original remote for this system (Fig. 2) is no longer available for use with this system.
LED Error Codes on the Controller
What?
Why?
What Should Be Done?
1 Green, 1 Red (one
solid, one flashing)
Stops need to
be programmed.
Refer to the manual Schwintek Motorized TV Lift,
Programming section, Setting the Extend and
Retract Limits.
1 Green (flashing
then goes off) 2 or 3
Red (flashing)
Low voltage.
Check the connections to the power source and/or
replace the power source.
1 Green (flashing
then goes off), 6, 8 or
9 Red (flashing)
Issue with wire harness to
motor or motor bad.
Check the wire harness connection and/or replace
the motor.
