6
lippertcomponents.com
574-537-8900
Rev: 11.17 - Solera
®
Universal Hardware Conversion
Solera
®
Universal Hardware
Manual Awning to
Solera Classic Manual Awning
(For Aftermarket Application)
19.
Remove the fasteners from the lower mounting bracket
(Fig.10A)
of the support arm assembly.
20.
Using the provided #10 - 32 x 2
1/2
” screws, secure the
Solera lower mounting bracket to the same location as the
previous bracket and using the same holes.
NOTE:
If for any reason the previous holes do not line up
with the pre-drilled holes in the Solera lower mounting
bracket, slide the provided spacer block between the wall
of the unit and the lower mounting bracket before securing.
This will help cover the holes and ensure a secure
mounting surface.
21.
Connect the bottom of the Solera support arm
(Fig.11A)
to the lower mounting bracket
(Fig.11B)
.
A
B
Fig.11
A
B
Fig.12
22.
Using the provided #10 - 32 x 3
1/2
” screws
(Fig.12A)
,
secure the Solera upper mounting bracket
(Fig.12B)
to the
same location as the previous bracket and using the same
holes.
23.
Release the travel lock, extend the support arm and
insert the top of the arm into the drive head, being sure to
align the holes.
A
B
C
Fig.13
24.
Secure the drive head
(Fig.13B)
to the support arm
(Fig.13C)
with the provided
1/4
- 20 x
1/2
” screw
(Fig.13A)
.
25.
Pull the rafter arm
(Fig.14A)
up and lock it into the drive
head
(Fig.14B)
on the support arm assembly.
26.
Remove the slack from the fabric and secure the
awning by tightening the tension knob
(Fig.15B)
on the
rafter arm
(Fig.15A)
.
Fig.15
A
A
A
B
Fig.14
B
