5
lippertcomponents.com
574-537-8900
Rev: 11.17 - Solera
®
Universal Hardware Conversion
Solera
®
Universal Hardware
Manual Awning to
Solera Classic Manual Awning
(For Aftermarket Application)
10.
Remove the spring assembly
(Fig.6B)
from the roll
tube
(Fig.6A)
.
15.
Apply tension to the spring assembly by turning the
drive head in a counterclockwise direction. The number of
turns is determined by the position and size of the awning.
Fig.6
A
B
11.
Locate the cam lock marking applied in Step 1 and
slide the Solera spring assembly into the roll tube so that
the cam lock lines up with the cam lock marking.
12.
Place the Solera end cap onto the roll tube, making
sure it is properly seated.
13.
Secure the Solera end cap
(Fig.7C)
to the roll tube
(Fig.7A)
with the provided rivets
(Fig.7B)
.
NOTE:
It may be necessary to drill out the previous holes
in order to accommodate the larger-sized rivets.
A
B
C
Fig.7
14.
Remove the cotter pin from the Solera end cap and
move the cam lock to the roll out position.
Awning Size
Number of Turns
Retracted
Extended
6’ - 10’
5
13
11’ - 14’
6
14
15’ - 18’
7
15
19’ and up
10
18
16.
Insert a cotter pin into the end cap
(Fig.8A)
once the
proper amount of tension has been set.
17.
Remove the fasteners from the upper mounting bracket
(Fig.9A)
of the support arm assembly.
18.
Detach the support arm assembly from the lower
mounting bracket.
NOTE:
If the awning is in the extended position the
springs will require more turns to set proper tension.
Fig.8
Fig.10
A
A
Fig.9
A
