10
lippertcomponents.com
574-537-8900
Rev: 11.17 - Solera
®
Universal Hardware Conversion
Solera
®
Universal Hardware
Manual Awning to
Solera Classic Manual Awning
(For Aftermarket Application)
16.
Insert a cotter pin into the end cap once the proper
amount of tension has been set.
17.
Remove the fasteners from the upper mounting bracket
of the support arm assembly
(Fig.25)
.
Awning Size
Number of Turns
Retracted
Extended
6’ - 10’
5
13
11’ - 14’
6
14
15’ - 18’
7
15
19’ and up
10
18
NOTE:
If the awning is in the extended position the
springs will require more turns to set proper tension.
18.
Detach the support arm assembly from the lower
mounting bracket.
Fig.25
19.
Remove the fasteners from the lower mounting bracket
of the support arm assembly
(Fig.26)
.
20.
Using the provided #10 - 32 x 2
1/2
” screws, secure the
Solera lower mounting bracket to the same location as the
previous bracket and using the same holes.
Fig.26
NOTE:
If for any reason the previous holes do not line up
with the pre-drilled holes in the Solera lower mounting
bracket, slide the included spacer block between the wall
of the unit and the lower mounting bracket before securing.
This will help cover the holes and ensure a secure
mounting surface.
21.
Connect the bottom of the Solera support arm
(Fig.27A)
to the lower mounting bracket
(Fig.27B)
.
A
B
Fig.27
