12
lippertcomponents.com
574-537-8900
Rev: 11.17 - Solera
®
Universal Hardware Conversion
Solera
®
Universal Hardware
Manual Awning to
Solera Classic Manual Awning
(For Aftermarket Application)
30.
Locate the nearest hole on the lower channel and make
a non permanent marking for the stop bolt location.
31.
Extend the awning 12”.
32.
Extend the support arm
(Fig.32B)
to gain full access to
the hole marked for the stop bolt
(Fig.32C)
.
33.
Insert the bolt into the marked hole from the inside of
the support arm
(Fig.32B)
and secure it with a lock washer
and acorn nut.
Fig.32
A
C
B
Operation
Extending the Awning
1.
Make sure the black locking knobs
(Fig.33C)
on
the rafter arm upper channel
(Fig.33B)
are loosened
and pinch the travel locks together to release the
outer arm
(Fig.33A and Fig.33E)
from the rafter arm
(Fig.33B and Fig.33D)
.
2.
Flip cam lock down to the roll out position.
3.
Using the pull rod, start pulling the awning outward until
full extension is complete.
4.
Slide the rafter arms
(Fig.33B and Fig.33D)
all the way
to the top of the outer arm
(Fig.33A and Fig.33E)
and
make sure they lock into place.
5.
Pull on the rafter arm
(Fig.33B and Fig.33D)
to ensure
the fabric is taut and tighten the black locking knob
(Fig.33C)
to lock it into place.
6.
Raise the outer arms
(Fig.33A and Fig.33E)
to the
desired height by releasing the support arm assembly
handle and allow the outer arm upper channel
(Fig.33A)
to slide on the outer arm lower channel
(Fig.33E)
. Once
to the desired height, let go of the support arm assembly
handle to lock the arm at this position.
7.
Slide the pull strap to one end or the other and wrap it
around the arm to get it out of the way.
Fig.33
A
E
B
D
C
