Rev: 01.15.20
Page 5
CCD-0002221
4.
Loosely place the internal prep plate assembly (Fig. 3) into the access hole.
A.
Connect the electrical wires of the DC jack harness (Fig. 3A) to the power and ground circuitry.
B.
Let the internal prep plate and DC jack harness lay loose across the access hole.
5.
Position the external cellular antenna prep plate (Fig. 4) in the desired mounting location on the roof of
the unit, close to the approximate location to where the internal prep plate (Fig. 3) is located.
A.
Make sure the external cellular antenna prep plate can lay flat against the roof's surface.
B.
With a non-permanent marking method, trace an outline along the outer lip of the external cellular
antenna prep plate (Fig. 4A) on the roof's surface. Set the external cellular antenna prep plate aside
for future installation.
C.
Using the point of the hole (Fig. 4B) where the coaxial cables will rest, as the starting point,
measure to the middle right side of the of the external cellular antenna prep plate. The
measurement should be approximately 8".
D.
Measure and mark the same distance in step 5C on the trace outline of the roof's surface.
Measure from the middle right side in towards the center, mark the location on the roof's surface.
E.
Using the point of the hole (Fig. 4B) where the coaxial cables will rest, as the starting point,
measure to the bottom side of the of the external cellular antenna prep plate. The measurement
should be approximately 3 3/4".
Fig. 4
Fig. 3
A
A
3
3/4
"
8"
B
