Rev: 01.15.20
Page 4
CCD-0002221
1.
Locate an area within the unit where the internal prep plate (Fig. 1A) can best be mounted.
NOTE:
Keep in mind when installing the internal prep plate that the future install of the Hotspot system
will need to be installed on a flat surface area and be located within 12" of the internal prep plate.
2.
If desired, create a template out of durable material, and similar to the dimensions specified in figure 2,
for the installation location of the internal prep plate.
NOTE:
Dimensions subject to change.
3.
Place the internal prep plate template flat and level against the designated mounting location to:
A.
Mark the center of the three
3/16"
diameter holes (Fig. 2).
B.
Set the drill template aside.
C.
Drill one 1
5/16"
diameter access hole through the center hole (Fig. 2).
Fig. 2
2
3/4
"
4
1/2
"
3/16
" Dia.
1
5/16
" Dia.
3/16
" Dia.
