Installation Guide Power Supply
DE
Page 4 / 12
Power range 480 W
NTI AG / LinMot
2 Safety instructions
Do not open!
Do not use without a PE connection.
Disconnect power before installing or removing.
For built-in use only!
This warning also applies in the event that an internal fuse blows in the appliance.
The appliance should generally only be opened and/or repaired by the manufacturer.
Appliances are approved for operation based on the connected loads and technical data
stated on the rating plate and the detailed data sheet only. Please read these carefully
before installing the appliance and commencing operation and take note of any
performance limitations, such as reduced output power (derating) in the event of high
ambient temperatures.
All appliances must be connected to a mains supply offering voltage quality which complies
with EN50160 standards. Operating the appliance via UPSs, current inverters etc. which do
not meet these standards may result in damage to the appliance. In such cases, no
guarantee claims will be accepted.
As a rule, appliances are intended for built-in use. They must be installed and connected by
qualified personnel.
Ensure that the surrounding casing protects the appliance against fire!
Heat loss occurs during operation of the appliance. To ensure safe performance and avoid
any possible risk of damage to the assembly itself and/or connected equipment, provision
must be made for adequate heat dispersal. Please observe the relevant instructions in this
document and the appliance.
Please take note of the information shown on the connection and pin configurations for this
appliance! Pay particular attention to the information on the wire cross-section and torque
and ensure that the wiring complies with prevailing standards.
If a load output is designed to take sensor cables, these must be connected to the
corresponding load lines to ensure safe operation of the appliance.
Appliances may be connected in parallel if this option is given in the technical data; max.
three identical appliances, otherwise please consult LinMot. Advice should normally be
obtained from LinMot before connecting appliances in series.
Trim potentiometers may not be used on appliances unless the relevant setting range is
given in the technical data and on the appliance, and the maximum output power is not
exceeded.
All appliances have been tested for compliance with the prevailing insulation and high-
voltage standards. Any additional tests of this kind which may be required should not be
carried out without the consent of the appliance manufacturer, LinMot. As there could be a
potential risk of damaging or destroying components in the appliance, it may be necessary
to take special precautions prior to such tests.
