Installation Guide Linear Motors
ENG
NTI AG / LinMot
P10-70-SSC / P10-70-SSC-D02
Page 21 / 32
Remove bearing tube.
Loosen the screws and pull out the bearing
tube on the rear side.
Remove the front end piece.
Loosen the screws and remove the end piece.
Mount a new bearing tube
Insert the seal into the bearing tube groove and
slide the bearing tube into the stator rear side.
Then screw the bearing tube.
Tightening torque:
2.4 Nm
Mount a new end piece.
Insert the seal into the groove and attach the
end piece to the front of the stator.
Then screw the end piece.
Tightening torque
2.4 Nm
