Installation Guide Linear Rotary Motors
ENG
NTI AG / LinMot
PR01-52
Page 39 / 48
5. Remove further dirt particles.
Move the slider of the linear motor or the
entire linear rotary shaft axially forwards and
backwards to remove further possible dirt
particles from the stator of the linear motor. If
necessary, repeat steps 1-4 of the
maintenance instructions until no more dirt is
visible on the slider. Make sure that only a
light film of grease remains on the slider.
Linear rotary motors may have grease nipples, which are used by LinMot for initial
lubrication. Linear rotary motors may have grease nipples which are required by LinMot for
initial factory lubrication. The customer is prohibited from using the grease nipples for
cyclical maintenance. For proper maintenance, refer to the following sections in this chapter.
8.3.2 Cleaning the Inside of the Linear Motor
•
The following work may only be carried out by NTI AG / LinMot GmbH or companies
qualified by LinMot.
•
The linear rotary motor may only be opened by trained personnel.
•
The motor may only be opened after the previous chapter "Cleaning the visible part of
the slider" has not produced the desired effect.
•
Opening of the motor by unqualified personnel will result in loss of warranty.
A full maintenance of the PR01 linear rotary motor can be ordered from NTI AG / LinMot (recommended).
Item
Description
Item-No.
Maintenance: PR01-52/PR02-52
Cleaning, replacement wear parts
Maintenance Linear Rotary Motors
r156
The motor shown below is representative for all linear rotary motors of the PR01 family.
Depending on the type of motor and revision, there are different mechanical versions.
It is the responsibility of trained personnel to handle the different versions accordingly. This
applies to disassembly and assembly.
1: Linear rotary shaft
5: Washer
9: Adapter part
2: Stator (Rotary Motor)
6: Mounting screws linear rotary motor
3: Stator (Linear Motor)
7: End part stator (Linear Motor)
4: Slider (Linear Motor)
8: O-Ring
