Installation Guide Linear Rotary Motors
ENG
Page 12 / 48
PR01-52
NTI AG / LinMot
4.3 Mounting the Load on the Shaft
The assembly and disassembly of the load mass must not take place in the mechanical end
stops of the linear movement. An external support must be used.
4.3.1 Feather Key
The load mass can be mounted via a feather key. For this purpose, a slot is machined into the end of the
shaft.
Ordering information
Item
Description
Item-No.
Parallel keys deep
pattern
face side domed / DIN 6885 A / ISO R773
4x4x10, steel C 45 K, plain
0230-0269
4.3.2
Shaft-Hub Clamping
The shaft-hub clamping is a non-positive
connection which is produced by means of two
conical rings.
The use of drivers or the production of grooves is
completely eliminated. The suitable shaft-hub
clamping type can be ordered from LinMot.
Mounting instructions and ordering information can
be found in the "Accessories" chapter.
4.4 Material Data
Component
Material
Linear rotary shaft
Quenched and tempered steel C60 (1.0601)
Front flange (Rotary motor)
Hard anodized aluminium (3.3206)
Housing (Rotary motor)
Hard anodized aluminium (3.3206)
Feather key slot
Linear rotary shaft
Front flange (rotary motor)
