2
Installing the Network Storage Link and OneTouch Drive
Connecting the Network Storage Link to Your Network
1.
Connect one end of an Ethernet cable to
the
Ethernet
port on the back of the
Network Storage Link.
2.
Connect the other end of the Ethernet
cable to your router.
Figure 1.
Connecting the Ethernet cable
Connecting the OneTouch Drive to the Network Storage Link
Important –
Make sure that the Network Storage Link is turned OFF before you connect
or disconnect your Maxtor OneTouch drive!
3.
Connect one end of the included USB
cable to your OneTouch drive.
4.
Connect the other end of the USB
cable to the
Disk 1
port on the Network
Storage Link.
Note:
You can only connect up to two
drives. Do NOT connect additional drives
using a USB hub.
Figure 2.
Connecting the USB cable
Powering Up the OneTouch Drive
5.
Connect the round female connector from
the power adaptor to the drive’s power
connector
6.
Connect the two-pin female connector on
the power cord to the power adaptor.
Figure 3.
Connecting the power
7.
Connect the standard 3-pin electrical plug to an AC power outlet (preferably a
surge-protected outlet).
8.
Turn on the OneTouch drive using the switch on its back panel.
Powering Up the Network Storage Link
9.
Connect one end of the power adaptor to the back of the Network Storage Link.
10.
Connect the other end of the power adaptor to an AC power outlet (preferably a
surge-protected outlet).
