© 2017 Linkam Scientific Instruments Ltd.
22
v1.1.0
This screen shows the serial number and firmware version of the connected LinkPad.
Key pad tones are enabled are enabled by ticking the 'Key sound' check box. To disable them, uncheck the box.
Alarms can be configured to sound at the start of each ramp and/or the start of each hold time in the profile by checking the respective option.
The volume of the key tones and alarms can be adjusted via the 'Volume' slider.
LNP options
The screen displays the serial number and firmware version of the connected LNP96, if present. This screen is for information only, no changes can
be made.
Option board Information
To get to the option board information touch the blue right arrow tab and to go back to the T96 system controller information touch the blue arrow
tab again (now pointing left).
Dual T/C Tab
T96 System Controllers connected to a high temperature stage require a dual thermocouple option board. This tab shows which stage is connected
and it’s serial number. The other input of the dual card will be blank.
Tensile Tab
T96 System Controllers setup for a tensile stage require a signal conditioning option board. This tab shows which beam type is connected to the
system, allows the user to select whether the display will show stress/strain or force/distance and true or engineering strain, allows a default
motor speed to be set and allows a distance calibration to be performed.
Note:
In order for Stress/Strain values to be accurate you must enter values for sample
width and thickness in the Tensile setup screen.
Vacuum Tab
T96 System Controllers setup for a Pirani vacuum gauge require a signal conditioning option board.
To change the displayed vacuum value between mBar, mTorr and kPa simply touch the desired radio button.
Pressure Tab
T96 System Controllers setup for a pressure gauge require a signal conditioning option board.
