Linhai M565L T3b, Owner'S/Operator'S Manual

Page: 66 / 105

M565Li T3 OWNER’S/OPERATOR’S MANUAL 19.0
14.
BATTERY
Battery Removal
1. Disconnect hold down straps holding the electrical box and battery in
position and remove battery cover.
2. Remove the battery vent tube from the battery.
3. Disconnect the black (negative) battery cable first.
4. Disconnect the red (positive) battery cable next.
5. Lift the battery out of the ATV.
Battery Installation and Connections
To avoid the possibility of explosion, always connect battery cables in specified
order: Red (positive) cable first; black (negative) cable last. An exploding
battery can cause serious injury or death.
Protect battery terminals from corrosion. If cleaning is necessary, clean them
with a stiff wire brush and then treat them with Electric contact cleaner, for
example Maxima Electrical Contact / Brake Cleaner. Then coat the terminals
with dielectric battery contact grease.
1. Set the battery in its holder.
2. Install battery vent tube. Tube must be free from obstructions and securely
installed. If not, battery gases could accumulate and cause an explosion.
The tube should be routed away from the frame and body to prevent
corrosion. Avoid skin contact with electrolyte, severe burns could result.
3. First connect and tighten the red (positive) cable.
4. Then connect and tighten the black (negative) cable.
5. Reinstall battery cover and attach the hold down strap.
6. Verify that cables are properly routed.
WARNING