Linear Acoustic LQ-1000 User Guide
Detailed Operation
28
•
VANC Async -
Enable for SMPTE 2020M “B” mode (i.e. CBS Metadata)
•
Test Tones
– See Below (duplicated in this menu for convenience)
•
Record Audio to USB
– Allows Input, Output, or Input+Output to be recorded to
a USB drive for troubleshooting purposes.
•
GPI Setup
– See Details Below
•
Time/Date Settings
– Set time, date, and NTP service for timestamping purposes.
See below for setup details
•
Prefere
nces:
•
Change Password
– The password is either entered here for the first time or
changed. Use the rotary knob and the right arrow key to enter your password, then
select
Save.
You will be prompted several times, and then you will be reminded not
to lose the password.
Please heed the warning!
If you do happen to lose it, please call us
to assist recovery without losing presets. If you wish to remove the password, simply
enter the old password, then enter nothing for the new one and select
Save
. You will
be prompted a few times, and then it will be removed.
•
LCD Shutoff
– Permanently set to Never as unit uses OLED display.
•
Reinitialize
– Fast reset of the system software and audio drivers
•
Save Settings Immediately –
Changes to the system are automatically saved over a
period of many minutes in order to minimize the chances of audible clicks and pops
that may occur during a save process. However, it is sometimes useful to be able to
save immediately. Selecting this function will do so, and will remind the user that it
takes a few seconds even after the function has been performed.
•
Save Settings to USB –
Allows unit settings to be stored to a factory supplied or fac-
tory approved USB device connected to the rear panel USB connector. When this de-
vice is installed in an LQ-1000 unit and the system is power cycled, a startup message
will prompt the user to allow restoring all settings of presets from USB.
•
Weekly Log to USB –
Saves rolling 7.5 day CSV loudness log file to USB
•
Update Software
– Allows software and firmware to be updated from the USB thumb
drive included with the unit using factory supplied updater file. Selecting this option
will force a system re-start, you will be prompted.
•
Power Cycle –
Slow reset of the entire system. Select this to perform a full system re-
boot and re-initialize; you are returned to the main menu.
Summary of Contents for LQ-1000
