SOD
A W
ATER MAKER
S
15
15. PUTTING INTO OPERATION:
1. Connect the device to CO2 supply.
2. Connect the device to water supply.
3. Check that all the joints and connections are sufficiently tight.
4. For SODA AS-45 GREEN LINE and SODA AS-110 GREEN LINE, fill the cooling tank with clean
water up to the overflow.
5. Connect the device to the power mains.
6. Switch on the device with the main switch (use thermostat for the SODA PYGMY GREEN LINE
model).
7. You can use the tap to dispense a drink.
WARNING:
If you discover a leak, turn off the device. Fix any leaks found on the tubing. If
a leak is found inside the device or you are unsure how to proceed, contact a service centre.
16. RECOMMENDED ACCESSORIES:
• AquaStop
• Water filter ( is required for the correct operation of the device)
• Water pressure reducer (is required for the correct operation of the device)
• Tubes and fittings
NOTE:
The recommended accessories are not included. The supplier is not liable for dam-
ages caused by not using this recommended accessory.
14.4 Keg Untapping:
Procedure for untapping a keg using an A-system keg coupler:
figure
15 a
figure
15 b
Max. inlet water temperature (beverages) 25 ° C.
