6
Ékszíjas meghajtású, olajkenésű, dugatt
LINCOS Slovenia
STD-3550
Two Post Lift - Electrical Release
Power supply: single phase/three phase (Please see nameplate before
connecting)
3 INSTALLATION
3.1 TOOLS AND EQUIPMENT
•
Appropriate lifting equipment
•
AW 32.46 or other good quality garage hydraulic oil
•
Chalk line and tape measure.
•
Rotary hammer Drill with 3/4” drill bit
•
Sockets and Open wrench set
•
Vise Grips
3.2 BEFORE INSTALLATION
1.
Identify the components and check for shortages. Contact us immediately if
shortage discovered.
2.
Installation, adjusting and testing operations are to be performed by qualified
staff only.
3.
The lift must be installed on a level concrete floor, having minimum thickness
of 15cm and an extension of at least 1.5m from anchoring points.
4.
The lift installation concrete surface must be relatively smooth, levelled in all
directions
5.
After unloading the lift, place it near the intended installation location. Remove
the shipping brands and packing materials from the unit. Remove the packing
brackets and bolts holding the two columns together.
SPACE REQUIRED
Please refer to the drawing for detailed installation size.
3.3 INSTALLATION STEPS
PLEASE READ THE FOLLOWING INSTRUCTIONS BEFORE ASSEMBLING THE
LIFT
STEP ONE: DETERMINE LOCATION AND MARKS WITH CHALK ON THE
FLOOR
1.
Determine which side will be the approach side and which side the power unit
to be mounted.
2.
Once the location is selected, use a chalk line to layout a grid for the post
locations and make an outline of the posts on the floor at each location.
3.
Before proceeding, double check measurements and make certain that the
bases of each column are square and aligned with the chalk line.
