Only use oils certified for gasoline
engines by the American Petroleum
Institute (API). An oil with this
trademark symbol conforms to the
current engine and emission system
protection standards and fuel
economy requirements of the
International Lubricants Specification
Advisory Council (ILSAC), comprised
of U.S. and Japanese automobile
manufacturers.
1. Remove the filler cap.
2. Add engine oil that meets the Ford
specifications. See
Capacities
and Specifications
(page 325).
3. Replace the filler cap. Turn it until
you feel a strong resistance.
Resetting the Oil Life
Monitoring System
Note:
Reset the oil life monitoring only
after an oil change.
1. Turn the ignition key to the on
position. Do not start the engine.
For vehicles with push-button
start, press and hold the start
button for two seconds without
pressing the brake pedal. Do not
attempt to start the engine.
2. Press both the accelerator and
brake pedals at the same time.
3. Keep both pedals fully pressed.
4. After three seconds, the Service:
Oil reset in prog. message will be
displayed.
5. After 25 seconds, the Service: Oil
reset complete message will be
displayed.
6. Release both the accelerator and
brake pedals.
7. The Service: Oil reset complete
message will no longer be
displayed.
8. Rotate the key to the off position.
For vehicles with push-button
start, press the start button to turn
the vehicle off completely.
ENGINE COOLANT CHECK -
2.0L ECOBOOST™/3.7L
Checking the Engine Coolant
When the engine is cold, check the
concentration and level of the engine
coolant at the intervals listed in the
scheduled maintenance information.
See
Scheduled Maintenance
(page
440).
Note:
Make sure that the level is
between the MIN and MAX marks on
the coolant reservoir.
Note:
Coolant expands when it is hot.
The level may extend beyond the MAX
mark
Note:
If the level is at the MIN mark,
below the MIN mark, or empty, add
coolant immediately. See
Adding
Engine Coolant
in this chapter.
The coolant concentration should be
maintained within 48% to 50%,
which equates to a freeze point
between -30 F degrees (-34 C) and
-34 F (-37 C).
268
Maintenance
Summary of Contents for 2013 MKZ
