b-2
OPERATION
b-2
1. POWER SWITCh
-
Place the lever in the “ON”
position to energize the machine. When the power is on
the output will be energized in STICK (SMAW) mode and
TIG (GTAW) if the remote is set to local control. At power
up the thermal Light and Fan will turn on for approxi-
mately 3 seconds.
2. OuTPuT CONTROL
-
This controls the output
current. Control is provided over the entire output range
of the power source with (1) turn of the control knob. This
control may be adjusted while under load to change
power source output. When using remote control this
function becomes the limit setting.
3. LOCAL/REMOTE SWITCh
-
Place in the
“LOCAL” position to allow output adjustment at the
machine. Place in the “REMOTE” position to allow output
adjustment at remote pot or amptrol. In Remote, the
machine output control pot is the limit setting for remote
control.
4. MODE SWITCh
CC -Stick (SMAW) Use this mode for all stick welding.
Output energized when machine is on.
TIG (GTAW) Optimized for touch start use. Short circuit
current is limited to approximately 20 amps to aid in touch
starting.
5. hOT START
-
Controls the amount of starting ener-
gy in CC Stick (SMAW). The Hot Start can be either
turned on or off. When on, it provides a striking current at
260% of the set current or 275A whichever is larger then
quickly reverts to the set current in 0.4 second.
6. ARC FORCE
-
This control functions in CC Stick
(SMAW) modes to adjust the Arc Force. The arc is
soft at the minimum settings and more forceful or
driving at the maximum settings. Higher spatter
levels may be present at the maximum settings.
Full range is from -10(Soft) to +10(Crisp)
ES 275i
CONTROLS AND SETTINGS
All operator controls and adjustments are located on the case front of the ES 275i. Refer to Figure B.1 and corre-
sponding explanations.
FIGuRE b.1 — CASE FRONT CONTROLS.
LOCAL
REMOTE
REMOTE
ARC FORCE
HOT START
-10
+10
OUTPUT
CC STICK
TIG
ON
ON
OFF
OFF
OFF
LOCAL
REMOTE
REMOTE
ARC FORCE
HOT START
-10
+10
OUTPUT
CC STICK
TIG
ON
ON
OFF
OFF
OFF
1
2
3
4
9
7
6
8
5
10
Summary of Contents for RED-D-ARC ES 275I
Page 29: ...NOTES ES 275i ...
