Lincoln Electric PF41, Operator'S Manual, Page: 16 / 25

English English 13
Wire Spool Loading
Wire spool type S300 and BS300 can be installed on the
wire spool support without adapter.
Wire spool type S200, B300 or Readi-Reel
®
can be
installed, but the applicable adapter must be purchased.
The applicable adapter can be purchased
separately(see "Accessories" chapter).
Wire Spool Type S300 & BS300 Loading
WARNING
Turn the input power OFF at the welding power source
before installation or changing a wire spool.
Figure 21.

Turn the input power OFF.

Open the spool wire case.

Unscrew the Locking Nut [35] and remove it from the
Spindle [37].

Place the spool type S300 or BS300 [36] on the
Spindle [37] making certain the Spindle Brake Pin
[38] is put in the hole in back side of spool type S300
or SB300.
WARNING
Position the spool type S300 or SB300 so that it will
rotate in a direction when feeding so as to be de-reeled
from bottom of the spool.

Re-install the locking nut [35]. Make sure that the
locking nut is tightened.
Wire Spool Type S200 Loading
WARNING
Turn the input power OFF at the welding power source
before installation or changing a wire spool.
Figure 22.

Turn the input power OFF.

Open the spool wire case.

Unscrew the Locking Nut [35] and remove it from the
Spindle [37].

Place the adapter of spool type S200 [39] on the
spindle [37] making certain the spindle brake pin [38]
is put in the hole in back side of the adapter [39]. The
adapter of spool type S200 can be purchased
separately (see "Accessories" chapter).

Place the spool type S200 [41] on the spindle [37]
making certain that the adapter brake pin [40] is put
in the hole in the back side of the spool.
WARNING
Position the spool type S200 so that it will rotate in a
direction when feeding so as to be de-reeled from
bottom of the spool.

Re-install the locking nut [35]. Make sure that the
locking nut is tightened.