6
When receiving the goods make sure that the product has
not suffered damage during the transport, that there has
not been rough handling or taking away of parts contained
inside the packing or in the set.
In case you find damages, rough handling or absence of
parts (envelopes, manuals, etc.), we advise you to inform
immediately our Technical Service.
For eliminating the packing materials, the User must keep
to the norms in force in his country.
1)Take the machine (C) out of the shipment packing.
Take out of the envelope (A) the user’s manual (B).
2)Fit the handle as shown in the instructions (fitting:
screws
and spanner are supplied).
3 ) Read: the user’s manual (B), the plates fixed on the
machine, the data plate.
In case you should transport or move the machine, keep
to the instructions as per the figures.
Be sure that the lifting devices are: correctly mounted,
adequate for the weight of the machine with it’s
packaging, and conform to local rules and regulations.
Only authorized persons involved in the transport of the
machine should be in the area of movement.
Transportation must always take place with the engine off,
electrical cables and starting battery disconnected and
fuel tank empty. Be sure that the lifting devices are:
correctly mounted, adequate for the weight of the
machine with it’s packaging, and conform to local rules
and regulations.
Only authorized persons involved in the transport of the
machine should be in the area of movement.
This equipment is built in compliance with standard IEC-
EN60974-10.
The equipment should be installed and used in
accordance with the information below to achieve
electromagnetic compatibility. The limits required by IEC-
EN60974-10 may not be adequate to completely eliminate
interference when the affected equipment is in close
proximity or has a high degree of sensitivity. In such cases
it may be necessary to use other measures to further
reduce interference
This Class A equipment is not intended for use in
residential locations where the electrical power is
provided by the public low-voltage supply system.
There may be potential difficulties in ensuring
electromagnetic compatibility in those locations,
due to conducted as well as radiated disturbances.
The user is responsible for installing and using the arc
welding equipment according to the manufacturer’s
instructions.
If electromagnetic disturbances are detected, then it shall
be the responsibility of the user resolve the situation with
the technical assistance of the manufacturer.
In some cases this remedial action may be as simple as
earthing the welding circuit (see note). In other cases, it
could involve constructing an electromagnetic screen
enclosing the welding power source and the work
complete with
associated filters
In all cases electromagnetic disturbances shall be reduced
to the point where they are no longer troublesome.
NOTE
: The welding circuit may or may not be
earthed for safety reasons. Changing the earthing
arrangements should only be authorized by a person
who is competent to assess whether the changes will
2
C
B
A
1