English
5
SAFETY MARK: This equipment is suitable for supplying power for welding operations carried out in
an environment with increased hazard of electric shock.
CYLINDER MAY EXPLODE IF DAMAGED: Use only compressed gas cylinders containing the
correct shielding gas for the process used and properly operating regulators designed for the gas and
pressure used. Always keep cylinders in an upright position securely chained to a fixed support. Do
not move or transport gas cylinders with the protection cap removed. Do not allow the electrode,
electrode holder, work clamp or any other electrically live part to touch a gas cylinder. Gas cylinders
must be located away from areas where they may be subjected to physical damage or the welding
process including sparks and heat sources.
EQUIPMENT WEIGHT OVER 30kg: Move this equipment with care and with the help of another
person. Lifting may be dangerous for your physical health.
The manufacturer reserves the right to make changes and/or improvements in design without upgrade at the same time
the operator’s manual.
Installation and Operator Instructions
Read this entire section before installation or operation
of the machine.
General Description
The OUTBACK 200 CE is a petrol engine powered DC
stick welding power source and 230 / 110 volt AC power
generator. The engine drives a generator that supplies
single phase power for the DC welding circuit, single
phase power for the AC auxiliary outlets.
The OUTBACK 200 CE engine driven welder is a unit
which ensures the dual function as:
a current source for are welding
current generator for generating auxiliary.
Unit meant for industrial and professional use. Powered
by an endothermic engine; it is composed of various
parts such as: engine, alternator, electric and electronic
controls, the fairing at a protective structure.
The assembling is made on a steel structure, on which
are provided elastic support which must damp the
vibrations and also eliminate sounds which would
produce noise
Location and Ventilation
The welder should be located to provide an unrestricted
flow of clean, cool air to the cooling air inlets and to avoid
restricting the cooling air outlets. Also, locate the welder
so that the engine exhaust fumes are properly vented to
an outside area.
Stacking
OUTBACK 200 CE machines cannot be stacked.
Lifting
The OUTBACK 200 CE weighs approximately 76Kg with
a full tank of fuel (70Kg without fuel). Lift bars are
mounted to the machine and should always be used when
lifting the machine.
WARNING
Falling equipment can cause injury.
Lift only with equipment of adequate lifting
capacity.
Be sure machine is stable when lifting.
Do not lift this machine using lift bars if it is equipped
with a heavy accessory such as trailer
Do not lift machine if lift bars are damaged.
Do not operate machine while suspended from lift bail.
Be sure that the lifting devices are: correctly mounted,
adequate for the weight of the machine with it’s packaging,
and conforms to local rules and regulations.