IS431 ECN3592
12
NOTE
Oven Thermocouple
Remove the pan supports, burner caps,rear access panel, hob top and oven liner tray.
Remove the thermocouple nut from the thermostat body G.
Remove the thermocouple lock nut from the burner and withdraw the thermocouple from
the bracket.
Tape the new thermocouple to the old thermocouple. Withdraw the old thermocouple
whilst feeding through the new thermocouple.
Re-assemble in the reverse order.
Control Valve and Oven Thermostat
Remove the control knobs, pan supports, burner caps, rear access panel and hob top.
Remove the nut from the gas output at the valve or thermostat.
Remove the thermocouple nut from the valve or thermostat.
Remove clamp screws D from the valve or thermostat.
Free the thermostat bulb from the oven bracket and feed through the oven liner.
Free the valve or thermostat from the manifold A.
Fit the new valve or thermostat and re-assemble reverse order.
Perform gas soundness test of circuit prior to operation of appliance.
Hob Burner
Remove the pan supports, burner caps, rear access panel and hob top as shown above.
Remove the burner body retaining screws JJ.
Note! It will be easier to lift off the hob top by undoing the securing brackets NN and the two
fixing screws MM at the rear.
Fit the new burner body and re-assemble parts.
Oven Burner
Remove the oven base tray and shelves.
Disconnect the ignition lead and remove thermocouple T by undoing lock nut V.
Undo the flexi hose from the coupling O and remove coupling O from burner.
Undo four fixing screws and remove burner.
Re-assemble in reverse order.
Perform gas soundness test of circuit prior to operation of appliance.
Oven Ignitor Electrode
Remove the ignitor lead at the ignitor.
Remove the ignitor retaining screw and nut.
Replace the ignitor.
Check that the ignitor is replaced correctly and ignites the pilot flame upon operation.
Piezo Ignitor
Remove facia panel
Disconnect the ignitor and ignitor earth leads.
Remove the retaining nut and withdraw from unit.
Replace and fit in reverse order.
