Page 5 of 28
Safety instructions:
Please read the following safety information carefully.
Ensure that all staff who are to connect, mount, or use the SMPS-T160 are in possession of the necessary
information and that they have access to this user manual.
Persons who do not have the necessary experience or knowledge of the product/products must not use
the product/products. Besides, persons with reduced physical or mental abilities must not use the product/
products, unless they are under surveillance or they have been thoroughly instructed in the use of the
apparatus by a person who is responsible for the safety of these persons.
Moreover, children must be under surveillance to ensure that they do not play with the product.
Before installation, re-installation or troubleshooting:
• Stop the application
• Switch off the power supply and pull out the mains plug
• Relieve the application of any loads, which may be released during the work
•
Before start-up:
• Make sure that the system has been installed as instructed in the User Manual
• System connection. The individual parts must be connected before the SMPS-T160 is connected to the
mains.
•
During operation:
• Ensure that the cables are not damaged
• Unplug the SMPS-T160 before moving the equipment
• If the control box makes unusual noise or smells, switch off the mains voltage immediately.
• Take care that the cables are not damaged.
• The product must only be used in an environment, that corresponds to its IP protection.
Device protection:
The SMPS-T160 contains several mechanisms to protect itself from being damaged due to excessive use.
• In case of overheating, the device will activate a thermal protection. No power output will be available until
the temperature is back again within normal operating range.
• In case of exceeding the current limit / failure in the actuator, the device will activate an overload protection.
Immediately after the situation has been remediated the power output will be available again.
Hot plugging:
• It is not allowed to remove or to add the output cable as long as the SMPS-T160 is powered by mains.
When the equipment is not in use
• Switch off the mains supply in order to prevent unintentional operation.
• Check the SMPS and joints regularly for extraordinary wear.
Chapter 1
