14
Sabina
™
II sit-to-stand lift • 7EN155106 Rev 1
www.hill-rom.com I www.liko.com
Problems while helping a patient get to his feet
The patient does not reach a sufficiently upright position - what is to be done?
Sometimes this is due to the patient’s state of health or mobility: weakened musculature, lack of strength and/or diminished
mobility in hip or knee joints. In order to get the best possible use out of Sabina sit-to-stand lift, there are some things to keep
in mind:
1 Connect the vest's inner strap loop (B) to the sling bar hooks.
2 Raise the lift mast to achieve higher lifting height. See adjustment of lifting height, page 6.
3 Try a smaller vest size. A smaller vest means a shorter distance to the hooks and a more upright standing position.
The patient has a hard time participating in the first part of the raising motion - what is to be done?
Sabina SeatStrap is an accessory meant for patients who need extra help with raising the seat during the first part of the
raising motion. For more information, see “Recommended Lifting Accessories,” page 10-11, or read the instruction guide for
Sabina SeatStrap.
Using Sabina sit-to-stand lift in Passive Lifting Situations
For passive lifting, we recommend a sling model that does not restrict the lifting height too much. Adjustment on a
case-by-case basis is always important to functionality and security. The patient’s overall mobility determines the choice of
sling model and sling bar.
Remember that the maximum load for passive lifting is reduced from 200 kg (440 lbs) to 150 kg
(330 lbs); this is due to the fact that during passive lifting, the foot rest does not bear any of the load.
Sabina sit-to-stand lift with SlingBar 350 (bar width 350 mm)
For this sling bar, we recommend Liko OriginalSling mod. 10 and 11, Liko HygieneSling mod. 40, 41, 45 and 46,
as well as the Liko Straps.
Sabina sit-to-stand lift with Comfort SlingBar (bar width 600 mm)
For this sling bar, we recommend Liko UniversalSling mod. 000 and 002, as well as Liko OriginalSling mod. 10 and 11.
See the
respective instruction guide for the sling model for more information or contact Hill-Rom for further guidance.
1. Disassemble the lower leg support: Unscrew screw A.
Pull out the lower leg support. Remove the foot rest: Grab
the front edge of the frame. Fold it up and lift it off the
base.
2. Apply suitable sling according to the sling’s instruction
guide. Above
Liko HygieneSling mod. 40 is applied.
Passive lifting using Sabina sit-to-stand lift with SlingBar 350
