16
www.hillrom.com
7EN120114 Rev. 10 • 2020
Simple Troubleshooting
The lift doesn’t work.
A repeated signal can be heard from the lift.
1.
Make sure that the emergency stop button has
not been activated (shall not be pressed in).
2. Check that the handcontrol cable is
connected
correctly.
3. Charge the battery.
4. If the problem persists, please contact Hill-Rom.
The lift emits a repeated LED signal.
1. Charge the battery immediately.
2. If the problem persists, please contact Hill-Rom.
1. Charge the battery immediately.
2. If the problem persists, please contact Hill-Rom.
The lift is stuck in the high position.
The lift does not achieve maximum lifting
capacity.
1. Make sure that the emergency stop button has
not been activated (shall not be pressed in).
2. Check that the handcontrol cable is connected
correctly.
3. Use the selected electrical emergency lowering
device to lower the patient onto a firm surface.
4. Charge the battery.
5. If the problem persists, please contact Hill-Rom.
1. Charge the battery.
2. If the problem persists, please contact Hill-Rom.
Please contact Hill-Rom.
In event of unusual sounds or any
leakage from the lift
