11
www.hillrom.com
7EN120114 Rev. 10 • 2020
SSP Limit Switch
The lifting motion is stopped
by lightly pressing on the SSP
Limit Switch on the underside
of the lift unit (see the
illustration).
SSP Limit Switch activated by the Q-Link or Q-Link II
When Likorall overhead lift strap reaches its highest position
and physical contact occurs between the SSP Limit Switch
and Q-Link or Q-Link II, the SSP Limit Switch is activated. Its
function stops the lifting motion electrically and protects the
lift unit against mechanical load. The SSP Limit Switch also
provides squeeze protection.
Adjustable friction brake
The amount of drag on the lift unit is adjusted
with the friction brake on the carriage. Turn
the brake clockwise for increased resistance
and counter clockwise to reduce resistance.
The following carriages have a friction brake:
prod. no. 3126011 and 3126015.
SSP Limit Switch activated by the Lift strap
It is important that the lift strap’s lifting motion is performed as vertically
as possible to ensure safe operation. The SSP Limit Switch is intended
to stop the lifting motion if the lift strap is subjected to harmful strain,
for example if it is pulled sideways or folded over during the lifting
motion. If the SSP Limit Switch is activated so that the lifting motion
stops, the lift can once again be operated after the lift strap is straight
again (a short delay may occur when re-starting the lifting motion is
normal in these cases).
Be aware that the lift strap is kept straight and
stretched when it runs in and out of the lift unit.
Never move the lift by
pulling the hand control!
1
2
A:
Losen the emergency lowering device strap.
B:
Fasten the emergency lowering device strap.
A
B