21
www.hillrom.com
7EN140108 Rev. 4 • 2020
Quick Guide
Prod. No
2000400
Liko Mobile lift system
(Fit´s "Holder for Quick Reference Guide", Prod. No. 2000100)
Recycling instructions
Waste of Electrical and Electronic
Equipment (WEEE).
Metals
Lead battery (Pb) or
Li-ION battery
Example: Transfer from wheelchair to bed
7EN190760 Rev.1
English
xxxxxxxxxxxxxxx
Liko AB
Nedre vägen 100
SE-975 92 Luleå , Sweden
www.Hill-Rom.com I www.liko.com
Quick Guide
Liko® mobile lift system
Important!
Verify the maximum load on each component.
The lowest rated component always state the
maximum load to the composite lift system.
Push in the sling
under itself, under
the patient.
Important!
Never use worn or
damaged components
in a lift system.
Disconnect
the sling.
Patient centered
over the bed.
Lift the patient.
Turn in and lower
the patient in the
center of the bed.
Place the sling
centered.
Finalize the transfer
Lifting and transferring
Preparing the lift system
Carefully remove the
sling under the patient.
The lift system in the example has
a Maximum load
=
200 kg*
*stated by the mobile lift.
The transfer is
completed.
Charge the
lift after use!
Important!
Before lifting,
always check the sling loops
in the sling bar hooks.
Safety instructions
Important!
Plan the transfer and compose
your lift system based on the
patient need´s and safety.
Read the User Manual for more information.
This Guide do
not replace
user manuals!
Mobile lift
Maxload: 200 kg
Sling bar
Maxload: 300 kg
Sling
Maxload: 250 kg
Example:
The lift system below is a composition of
3 components, all with different maximum load;
Note!
When lifting from floor
use locked wheels and
a pillow under the
patient’s head.
(C)2016. Lik
o R&D AB. All Righ
ts R
eser
ved.
Mobile lift towards:
Chair / Wheelchair
Mobile lift towards:
Bed
Mobile lift towards:
Patient on the floor
Important!
All sling bar
hooks shall carry the load
for a balanced and safe lift
.
Cross the leg support loops
through each other.
Seek short and low
lifting of patients
during transfer!
Old batteries are to be deposited at the nearest recycling station or given to personnel authorized by Hill-Rom.
Hillrom evaluates and provides guidance to its users on the safe handling and disposal of its devices to aid in the
prevention of injury, including, but not limited to: cuts, punctures of the skin, abrasions, and any required cleaning and
disinfection of the medical device after use and prior to its disposal. Customers should adhere to all federal, state, regional,
and/or local laws and regulations as it pertains to the safe disposal of medical devices and accessories.
If in doubt, the user of the device shall first contact Hillrom Technical Support for guidance on safe disposal protocols.
