Lika SMAX-AI1-PRG-L2, User Manual

Page: 32 / 84

SMAX MODBUS®
on the device. These items are described in the “7.1.2 Input Register parameters”
section on page 69 of this manual.
In this group box the items listed hereafter are available.
Continuous reading
When you press the
Continuous reading
button you enable the transmission of
continuous commands to read the Input Registers uninterruptedly. After
pressing the button, its background is coloured orange and a green progress bar
appears beneath the button to indicate that a reading operation is being
executing. A further green progress bar and the label
Busy over the drop-down
box of the
Select serial com
field indicate that the serial port is open. The items
in the
FUNCTIONS
and
HOLDING REGISTERS
group boxes are made
unavailable. The values of the Input Registers listed in the page are updated
without cease. To stop the continuous reading press the
Continuous reading
button once again. To send a single command to read the registers
(instantaneous reading) press the
Read params
button in the
DEVICE
group
box, see on page 30.
Current position
It shows the current position of the device expressed in counts. The value does
not appear if an error is active in the device. See the
Current position [0001
hex]
register on page 70.
Speed
This register is not used currently and reserved for future use. See the
Current
velocity [0002 hex] register on page 70.
SW version
It shows the version of the software that is installed currently (both as a decimal
value -256 in the Figure- and as a string -V1.0 in the Figure). See the
SW
Version [0004 hex]
register on page 71.
HW version
It shows the version of the hardware (PCB version) that is installed currently
(both as a decimal value -256 in the Figure- and as a string -V1.0 in the Figure).
See the
HW Version [0005 hex] register on page 72.
MAN SMAX MB E 1.2 Quick reference 32 of 84