LiGo DORO COMFORT 3005, Setup & User Manual

Page: 5 / 21

English
Installation
This device is intended for the analogue telephone network lines in AT, BE, BG, CH, CY,
CZ, DE, DK, EE, ES, FI, FR, GB, GR, HU, IE, IS, IT, LV, LT, LU, MT, NL, NO, PL, PT, RO,
SI, SK, SE.
Connection
1. Connect the curly cord to the handset and then to the socket marked
q
on the unit.
2. Connect the mains adapter (if included) to an electrical wall socket and then to the
socket marked
DC 9V
on the unit.
3. Connect the telephone line cord to a network wall socket and then to the socket marked
K on the unit.
4. Lift the handset and listen for the dial tone.
5. Position the cables in the grooves underneath the unit.
Note!
Use supplied telephone line cord, an existing cord from a previous phone may not be compatible.
Setup
1. Press
w
.
2. CONTRAST is displayed. Press
0
to change, press
V
to continue without changes.
3. Select desired contrast setting (2=normal) using v / V . Press
0
.
4. TIME/DATE is displayed. Press
0
to change, press V to continue.
5. To set hour (00-23) use
v
/
V
. Press
0
.
6. Select desired minute using
v
/
V
. Press
0
.
7. Select desired month using v / V . Press
0
.
8. Select desired date using v / V . Press
0
.
9. Select desired weekday using
v
/
V
. Press
0
.
10. ENGLISH is displayed. Press
0
to change, press
V
to continue.
11. Select desired language using v / V . Press
0
.
12. VOICE is displayed. Press
0
to change, press V to continue.
13. Select ON or OFF using
v
/
V
. Press
0
.
14. RECALL is displayed. Press
0
to change, press
V
to continue.
15. Select the desired setting using v / V .
100
for AU/UK/EU,
270
for FR and
600
for
NZ. Press
0
.
16.
ANSWER DELAY
is displayed. Press to change, press V to continue.
17. Select 2 , 4 or TS using v / V . Press
0
.
18. ANSWER MODE is displayed. Press
0
to change, press
V
to continue.
19. Select ANSWER/RECORD or ANSWER ONLY using
v
/
V
. Press
0
.
20.
PIN CODE
is displayed. Press
0
to change, press V to continue.
21. Use the numeric keypad to enter the code (default=0000). Press
0
. Enter the new
code (4 digits). Press
0
. If the code is not accepted/correct you will hear a short beep,
repeat step 19 and 20.
22.
PRIVACY MODE
is displayed. Press
0
to change, press V to continue.
23. Select
ON
or
OFF
using v / V . Press
0
.
To change settings for time, language or contrast etc. later on, repeat steps as above.
1