![background image](http://html.mh-extra.com/html/lightwaverf/jsjslw452/jsjslw452_instruction-manual_1915553007.webp)
• The 2-Way Dimmers use standard 3-core connecting cables; however,
because they are electronic dimmers, they utilise one of the cores as a
signal cable (‘S’) running between the Dimmers (as shown on the diagram).
This is low voltage only and should not be connected to 230V mains
;
serious damage will occur.
• Up to six 2-Way Dimmers (six gangs) can be connected to a standard
LightwaveRF Dimmer Switch. Each 2-Way can be connected directly to the
standard Dimmer, or connected to each other in a ‘daisy-chain’. This
provides an alternative to using intermediate switches (maximum cable
length of 100m).
VERY IMPORTANT
• A LightwaveRF 2-Way Dimmer (each gang) needs to be used in conjunc-
tion with a standard LightwaveRF Dimmer to perform 2-Way Switching.
The
LightwaveRF 2-Way Dimmer cannot
be used in conjunction with a
standard lightswitch.
This will cause damage to the Dimmer.
•
Never install and run power to a 2-Way Dimmer before first installing and
connecting the corresponding standard LightwaveRF Dimmer. Serious
damage could be caused to the unit.
Installation
Summary of Contents for JSJSLW452
Page 2: ......