Page 56 / 78
Section 7.
Programmer’s reference
7.3.18. Reload factory default IP settings
Description
: After issuing this command over serial connection the router will
reload the factory default IP setup.
Format
Example
Command {IP_CONFIG=!}
→ {IP_CONFIG=!}
Response (Changing IP
configuration…)CrLf
← (Changing IP configuration…)CrLf
(DONE!)CrLf or
(FAILED!)CrLf
(DONE!)CrLf or (FAILED!)CrLf
Parameters after successful command execution:
Parameter
Value
IP address
192.168.254.254
port number
10001
Subnet mask
255.255.0.0
Gateway
0.0.0.0
Info
IP settings can NOT be changed with this protocol command via Ethernet
connection, only via serial port. To change the IP settings via Ethernet, use the
Matrix Controller software (section
4.6.1
) or the built-in website (section
5.6
).
Default setting can be reloaded by the front panel buttons as well (section
3.3.2
).
7.3.19. Load DHCP IP settings (only IP address!)
Description
: After issuing this command over serial connection the router will
inquire IP address with DHCP.
Format
Example
Command {IP_CONFIG=D}
→ {IP_CONFIG=D}
Response (Changing IP
configuration…)CrLf
← (Changing IP configuration…)CrLf
(DONE!)CrLf or
(FAILED!)CrLf
(DONE!)CrLf or (FAILED!)CrLf
Parameters after successful command execution:
Parameter
Value
IP address
Acquired with DHCP
port number
unchanged
Subnet mask
unchanged
Gateway
unchanged
Info
IP settings can NOT be changed with this protocol command via Ethernet
connection, only via serial port. To change the IP settings via Ethernet, use the
Matrix Controller software (section
4.6.1
) or the built-in website (section
5.6
).
Default setting can be reloaded by the front panel buttons as well (section
3.3.2
).
Summary of Contents for MX12x12DVI-Slim
Page 1: ...User s Manual MX16x16DVI Slim MX12x12DVI Slim ...
Page 2: ...Page 2 78 ...
