Lightspeed 800IX, User Manual

Page: 26 / 48

8 0 0 i X U s e r M a n u a l
21 | 800iX User Manual
4.
While speaking in a normal voice slowly
increase the volume of the corresponding
channel on the 800iX until your voice
is barely audible.
REMEMBER: This
equipment supplements the user’s voice so
they are able to speak in a conversational
tone. Having the volume set too high will result in feedback and listener fatigue.
NOTE: A nominal volume level must be set on the 800iX before adjusting controls on the
REDMIKE VC.
INITIAL SET-UP OF OPTIONAL REDMIKE VC
5. The
teacher can now use the controls on the
REDMIKE VC to adjust the volume level from
anywhere in the room. The microphone volume
control has 4 steps up and 4 steps down from
the mid point (9 levels total).
1. Turn
the 800iX power switch to the ON
position. The RED LED on the switch
will glow.
2. Turn on the REDMIKE VC. The RED IR LED on the 800iX
will light to indicate a signal is being received.
3. Slip the REDMIKE VC with lanyard around the neck and
position the top of the microphone just below the collarbone.
NOTE:
Positioning of the REDMIKE VC is critical for proper
volume adjustment.
Helpful Hint
NOTE:
Each REDMIKE VC
has its channel pre-set to
either A or B, as indicated
on the back of the Mic.