Page
2
of
4
FXLD120EW LED FIXTURE
Version 0.1
OWNERS MANUAL
05/18/2013
www.lightronics.com
Lightronics
Inc.
509
Central
Drive
Virginia
Beach,
Va
234354
757
486
3588
DMX TERMINATION
A DMX chain should be terminated at the last
receiving device on the chain. This is done by
installing a commonly available 1/4 Watt, 120 Ohm
resistor across the DATA - and DATA + wires at the
last device. If you have only a few fixtures very close
together and a very short run to the controller then you
may be able to operate without the terminator.
OPERATION
A power ON/OFF switch is located at the rear of the
unit. A control panel on the back of the unit is used to
set the operating options. It consists of an LED display
and four buttons
(ESC, ENTER, DOWN, and UP)
.
Use
UP
and
DOWN
to scroll the available choices.
Push
ENTER
when you reach the option you want to
check or set. The current setting for the option will be
shown. Use
UP
and
DOWN
to change the setting.
Push
ENTER
to invoke the new setting. Use
ESC
to
exit from the sub menus.
DMX OPERATION
Use the
A - - -
menu to set the unit DMX starting
address. The range is
r001 - r511.
NOTE
The current version of the FXLD120EW will not
respond to DMX addresses above 255 even though
the addressing menu allows selections up to 511.
The fixture uses two DMX channels allocated as
follows:
CHANNEL 1:
Fixture Intensity (000 - 255)
CHANNEL 2:
Strobe Control (000 - 255)
000
is
Strobe
OFF
DEMO MODE (
dEnO
)
The
DEMO
mode has 4 choices as follows:
SC00
External DMX control
SC01
Slow fade ON/OFF (stand alone operation)
SC02
Strobe effects (stand alone operation)
SC03
ON/OFF sequence (stand alone operation)
SC00 must be used when operating with an
external DMX controller.
If the unit was switched to another
DEMO
mode then it
must be returned to
SC00
and then a RESET
(
rESt
)
must be done.
NAST MODE
This function is not currently supported.
RESET (
rESt
)
The reset function enables DMX operation after stand
alone operation.
Push
ENTER
when
rESt
is shown. The display will
show
OFF
. Push
UP
to execute the reset. The display
will revert to show the DMX starting address.
MAINTENANCE AND REPAIR
TROUBLESHOOTING
Check that you have power applied to the unit.
Check the DMX control cable.
Check the address settings of the unit and controller.
CLEANING
DISCONNECT THE POWER CORD BEFORE
HANDLING THE UNIT.
PIN #
SIGNAL NAME
1 DMX
COMMON
2
DMX DATA -
3
DMX DATA +
4 NOT
USED
5 NOT
USED
ESC
UP
DOWN
ENTER
CONTROL PANEL
DANGER DO NOT OPEN UNIT
RISK OF ELECTRIC SHOCK
RISK OF FIRE
