4
USER INSTRUCTIONS
LIGHTFORCE.COM
STEP 1. MOUNT THE LIGHTS
1. Locate a suitable mounting position to install the
driving lights.
2. Remove the nyloc nut and M10 washer from
M10 x 35mm bolt attached to the bottom of
mounting bracket
3. Locate the bracket in a suitable position using
the M10 x 35mm bolt. It is recommended that
the base area of the mounting bracket is totally
supported
4. Align the light to preferred driving position
5. Fit the washer and M10 nyloc nut, then tighten
using a 17mm socket and ratchet to specified
torque (35Nm). Do not use rattle guns
6. Tighten 2 x M10 x 35 side bolts to recommended
torque (35Nm).
WIRING HARNESS INSTALLATION
STEP 2. INSTALL THE RELAY AND
CONNECT THE LIGHTS
1. Remove the main ground wire from the negative
battery terminal. WARNING: This may result in
loss of radio security code and clock settings.
Please consult your owner’s manual before
disconnecting
2. Mount the 35 amp relay (see figure 1) in a
suitable place within the engine bay, using the
screw supplied (figure 2) and your drill with
a Phillips head driver bit. Ensure that the red
(positive) and black (negative) ring terminals
reach the appropriate battery terminals.
3. DO NOT CONNECT TERMINALS TO THE
BATTERY AT THIS STAGE
4. Route the insulated sleeved wires that run from
the relay to the driving light connectors to each
of your installed driving lights and connect the
driving light connectors to the back of each light.
Ensure that cables do not touch the radiator or
come in contact with any sharp edges
5. Secure all excess wire to the vehicle with cable
ties supplied. (See Page 6)
STEP 3. FULL INTENSITY MODE ONLY
1. Select the HB3 or H4 patch harness (refer to
your vehicle’s owner’s manual and figures 5
and 6 below to determine which is correct)
and connect it to a headlight connector on your
vehicle. If your headlights are a type other than
HB3 or H4, see item 3 below.
2. Connect the high beam pickup wires on the
driving light harness to the patch harness, red to
red, green to green.
3. NOTE: if you are installing into a vehicle with
headlights that are NOT HB3 or H4, you will
need to remove the bullet terminals on the red
and green high beam pickup wires on the driving
light harness (see figure 1) and crimp each wire
into a blue insulated male spade terminal using a
crimping tool. Then clamp the provided t-taps to
the high beam positive & negative wires on one
of the vehicle’s headlights. Use the red or blue
t-taps depending on the wire diameter. Finally,
connect the blue insulated male spade terminals
into the t-taps on the harness.
Green
Red
Blue
Fig 6.
H4 patch harness
Green
Red
Fig 5.
HB3 patch harness
Headlight
connector
Headlight
connector