rev. 0
P. 20
NOTE: Please refer LightBurn instruction manual and tutorials in their site for
configuration and usage
If you are using LAN connection, input the same IP address set on the laser controller.
NOTE: Please make sure LAN cable is connected between computer and laser
machine.
4)
Click “Devices”. Follow the steps given by LightBurn.
OR Click “Create Manually” ( if “Auto detect” does not find the machine)
5)
Select e.g. Ruida” / “Trocen” in New Device Wizard”, click “Next”
6)
Choose “Ethernet/UDP”
7)
Input the IP address you have seen in the DSP control panel e.g.169.254.169.041
8)
Input the Name you would like to call it
9)
Input the dimensions of the work area e.g. 1300mm for the width, 2500mm for the
height
10)
Select the origin, then click “Next”
11)
It will show the setting, then click “Finish”
